Pelco DX8000-UPDVD

C1604M (6/04) 19

4. Reinstall the unit in a rack enclosure if necessary, and reconnect all cables and peripheral equipment that you

removed earlier.

3. Plug the power cord back into the power supply and then into the wall.

4. Turn on the power switch and allow the unit to start up and find the new DVD-RW. This may take several minutes.

ON/OFF

Figure 17. Restarting Unit

Contents

Main Page Introduction Getting Ready Tools Needed Parts List Page Page Prepare Unit for Drive Installation OPEN THE UNIT CHASSIS Getting Ready Page 8C1604M (6/04) COMPONENT LAYOUT Figure 6. DX8000 Interior REAR OF DVR FRONT OF DVR Page Page Page Page Page Page RECONNECT THE DATA CABLE AND POWER WIRES Page Page Page Page Page PRODUCT WARRANTY AND RETURN INFORMATIONPRODUCT WARRANTY AND RETURN INFORMATION If you are located within the continental U.S., Alaska, Hawaii or Puerto Rico, send goods to: