Pelco es30-isap PAN AND TILT

6C312M-A (12/02)

PAN AND TILT

1. Remove the transformer module from the base of the system by loosening the four Phillips screws and lifting the module.

01475

BASE

MOUNTING

SCREWS

MOUNT

LOOSEN

PHILLIPS

SCREWS

TRANSFORMER

MODULE

BASE

2. Attach the base of the system to an Esprit mount (EWM or EPP) with the three flathead 10-32 x 1/2-inch screws and washers

(supplied).

Figure 3. Transformer Removal

Figure 4. Base Installation on Mount

NOTE: The illustration shows the ES30-ISAP Pan and Tilt System mounted to an EWM wall mount.

Contents

Main CONTENTS LIST OF ILLUSTRATIONS LIST OF TABLES DESCRIPTION MODELS INSTALLATION POD 100 PAN AND TILT Page Appendix TXB SERIES TRANSLATOR BOARD INSTALLATION (OPTIONAL) Page OPERATION POWER-UP DISPLAY Operating Notes PAN AND TILT OPERATION CAMERA OPERATION (POD 100 THERMAL IMAGER) OPERATING NOTES ENVIRONMENTAL RANGE PAN AND TILT FUNCTIONS PAN, SCAN, AND TILT SPEEDS LENS FUNCTIONS RANDOM, FRAME, AND AUTO SCANNING ZONES Park Time Minutes Zone Blank PATTERNS QUICK START GUIDE SYSTEM SETUP PROGRAMMING GUIDE ES30-ISAP PAN AND AND TILT SYSTEM MAIN MENU Power Up Menu Line Sync Menu HOW TO ACCESS THE MAIN MENU (PRESET 95) CAMERA Camera Menu LIMIT STOPS TURNING LIMIT STOPS ON OR OFF PROGRAMMING LIMIT STOPS Manual Limit Stops Limit Stop Menu Clear Manual Stops SCAN LIMIT STOPS Presets Limit Stops Menu Clear Scan Limit Stops LINE SYNCHRONIZATION Line Sync Menu PATTERN LENGTH Main Menu Other Menu PARK TIME MINUTES POWER-UP MODE Power Up Menu PROPORTIONAL PAN SCAN SPEED SPEED PROFILE ZONES ZONE BLANK Zone Blank Menu PRODUCT SUPPORT ES30-ISAP PAN AND TILT SYSTEM CONTACT: POD 100 THERMAL IMAGER (CAMERA) CONTACT: APPENDIX NOTES: Table B. Switch Settings for SW2 (Continued on next page) Table B. Switch Settings for SW2 (Continued) (Continued on next page) Page SPECIFICATIONS (PAN AND TILT SYSTEM ONLY) ELECTRICAL MECHANICAL GENERAL C312M-A (12/02) 31 REGULATORY NOTICES