8C312M-A (12/02)
8. Plug the male Esprit system connector, located on the bottom of the pan and tilt, into the female Esprit system connector located on
the transformer module. Align the pan and tilt part number with the alignment label on the base, and then attach the pan and tilt to
the base with three 1/4-20 nuts and washers (supplied).
PART
NUMBER
ALIGNMENT
LABEL
MALE SYSTEM
CONNECTOR
FEMALE
SYSTEM
CONNECTOR
Figure 6. Pan and Tilt Installation
9. Set the receiver address and system baud rate by configuring DIP switches SW1 and SW2.
To set the DIP switches:
a. Remove the plug from the left cover of the pan and tilt. It is not necessary to remove the pan and tilt cover.
b. Set the baud rate (SW1) and receiver address (SW2). For switch settings refer to Tables A and B in the
Appendix.
c. Replace the plug.
NOTE: Switch settings have no effect on Coaxitron control signals. The Esprit will sense and automatically select input from Coaxitron
control signals in either standard or extended mode.