6 C2428M-B (1/06)
CAMERA AND LENS INSTALLATION
1. To install the camera and lens onto the enclosure sled:
a. Extend the lens to the maximum length.
b. Position the camera and lens so that they do not extend beyond the track.
c. Fasten the camera and lens to the sled with the two, 1/4-20 x 0.375 Phillips screws
(supplied).
The edges of the sled are bent, one side up and the other side down. One side of the sled has
a wide lip and the other side has a narrow lip. In a typical installation, you mount the camera
so that the holes in the wide lip of the sled fit over the sled mounting screws. However, you can
elevate the sled if you are installing a camera with a low optical centerline or a camera with a
large diameter lens. To elevate the sled, flip the sled over so that the holes in the narrow lip of
the sled fit over the sled mounting screws.
2. Install the sled and camera assembly into the enclosure. Slide the sled over the mounting
screws and lightly tighten the screws.
3. Pull the power wires and cables through the glands or conduit into the enclosure. Refer to
Tables A and B to determine the size of the power wire to use. Refer to Table C for the type of
video coaxial cable to use.
NOTE:
Be sure to route wiring to maintain separation between 120/230 VAC, 24 VAC, and video
wiring.
4. Connect the cables for power and video to the camera.
5. You will need to access the PC board to wire the heater and defroster to power. To remove the
cover, insert a screwdriver into the slot on top of the cover and lift the cover off.
To connect the heater and defroster to power, refer to Figure 1 for wiring information. Connect
ground to the stud on the bottom of the enclosure just in front of the PC board.
Replace the PC board cover, making sure it snaps securely back into place.
6. If the camera lens is adjustable, extend the lens to its maximum length; verify that the end of
the lens is a minimum of 0.500-inch from the enclosure window.
7. Tighten the screws that secure the sled to the enclosure.
8. Adjust the glands for a tight fit around the cables.
9. Close the enclosure lid, and latch.
10. Adjust the camera focus and iris if necessary. If you need to adjust the focus and iris manually,
open the enclosure lid, adjust the focus and iris, and close the enclosure lid.