Pelco ICIICISS45 manual Programming

Programming

Inter-Check®must have communication parameters programmed in order to communicate with the ISS45 terminal. Make certain the security CCTV equipment is correctly installed before programming the system. Refer to the Inter-Check®ICI1000S Series installation/operation manual for complete information about system programming and CCTV equipment installation. Perform the following steps to program the Inter-Check®communication parameters:

1.Locate the NV switch beneath the ICI1000S video text inserter and position the switch towards the BNC connectors.

2.Turn on power to the ICI1000S system.

3.Perform the following using the programming keypad on the ICI1000S video text inserter (all menu items are displayed on the security monitor):

a.Enter the Main Menu programming mode by pressing ENT on the ICI1000S keypad.

b.Press 6, then press 8.

c.When the ICI1000S displays the message LOADED on the monitor, press the ESC key.

d.After the ICI1000S reinitializes (monitor display reads SYSTEM INITIALIZED), press the ENT key.

e.Press 1, then press 2.

f.Press the up arrow key twice (the up arrow key has a green dot beside it and is lo- cated by the number 9 on the keypad).

g.Press the ESC key when the monitor display reads RS-232 STANDARD PRINTER.

h.Press the ESC key three times to reinitialize the ICI1000S (monitor display reads

SYSTEM INITIALIZED).

4.Locate the NV switch beneath the ICI1000S video text inserter and return it to its original position away from the BNC connectors.

5.The Inter-Check®system is now programmed and ready to receive data from the ISS45 terminal.