POLE MOUNTING
1.Install the PA402 mount adapter. Refer to the instructions supplied with the adapter.
2.Open the lid of the
3.Attach the
CONDUIT
FITTINGS
PA402
Figure 2. Mounting to Pole with PA402
4.Run conduit with wiring from the positioning system to the IPS-RDPE-2. To connect the wires to the IPS-RDPE-2, refer to Figure 3 or to the label attached to the inside lid of the data port box, and do the following:
a.Connect the communication wires from the positioning system to the communication connector of the IPS-RDPE-2.
NOTE: Connect all four communication wires from the Spectra dome system or ExSite system to the
b.Connect the power wires from the positioning system to the 24 VAC OUT positions on the power connector of the
c.Connect the video wires/cable from the positioning system to either the BNC VIDEO IN connector (if using coaxial) or UTP VIDEO IN connector (if using UTP) of the
5.Run conduit with wiring from the power supply and wiring from the controller at the
WARNING: Turn off power to the power supply before wiring the power to the
a.Connect the power wires from the power supply to the 24 VAC IN positions on the power connector of the
b.Connect the wires/cable from the controller at the
7 |