Operating the dishwasher
Program sequence indicator lights (16)
Once a program has been started the program sequence indicator lights (16) show which stage of a program is cur- rently in progress.
Time display (15)
The running time of the program se- lected shows in the time display (15) in hours and minutes before a program is started. During a program the time left until the end of the program is dis- played. The “Time Left” indicator light next to the time display lights.
The time displayed for a program may vary. This is because of the water inlet temperature at each intake and be- cause of the load size being washed.
When the dishwasher is turned on the display shows an average time for a cold water intake.
Times shown in the program chart refer to normal loads and average tempera- tures and are for guidance only.
Each time a program is run the elec- tronic unit takes into account the new conditions and calculates the program time required. This new figure is then displayed.
Light ring (18)
The light ring illuminates when the dish- washer is turned on and goes out at the end of a program.
It will come on again if the program se- lector is turned to “Stop” or the door is opened and then closed again.
If the “Delay Start” function is activated the light ring will go out 10 minutes after you have set the delay start time.
It will come on again for 10 minutes if a button on the control panel is pressed or if the program selector is moved dur- ing this delay period.
32
