Before using for the first time
Programming and setting the water hardness level
The water hardness level of your water supply must be programmed into the dishwasher using the buttons on the control panel. The water hardness selector in the wash cabinet is then also set to the water hardness level in your area.
Programming and changing the water hardness level
The water hardness level which has been programmed into the machine can be checked and adjusted by using the buttons on the control panel.
^Turn the appliance off with the “On/Off” button.
^Press $ and “Start” simultaneously and at the same time turn the dish- washer on using the “On/Off” button.
A “P” and 2 figures will appear in the time display.
^Turn the program selector to “Sani Wash”.
The value corresponding to the pro- grammed water hardness level e.g. “22” will appear in the time display.
The water hardness level is 22 gr/gal (400 ppm).
If the water hardness level in memory is the correct one:
^Turn the appliance off with the “On/Off” button.
If you wish to program a different water hardness level:
^Press the “Top Solo” button repeat- edly until the value corresponding to your water hardness level appears in the display. This figure will be in gr/gal. For instance if your water hardness level is 30 gr/gal (540 ppm) then the figure “30” will show in the display.
Note:
Once the figure “36” is reached the counter returns to “1”.
^Press the “Start” button.
“SP” appears in the time display.
^Press the “Start” button again.
The new water hardness level is stored in memory.
The running time of the program which the selector dial is set to is now shown in the display in hours and minutes.
The “Time Left” indicator next to the time display lights up.
^Turn the program selector to the “Stop” position.
^Turn off the dishwasher with the “On/Off” button.
14
