Miele G 886 manual Indicator light, Intake/Drain is flash, Ing shortly after, Program has started

Problem solving guide

Problem	Possible cause	Remedy
The indicator light	The water valve is closed.	Open the water valve
“Intake/Drain” is flash-		completely.
ing shortly after the		If the program still does
program has started
		not start:
		– Turn the program se-
		lector to the “Stop” po-
		sition.
		– Turn the dishwasher off
		using the “On/Off” but-
		ton.
		– Start the program
		again.
	The water pressure at the	Call a plumber.
	intake is lower than 5 psi
	(0.3 bar).
	The water inlet filter is	Before fixing the problem
	blocked.	you must:
		– Turn the program se-
		lector to the “Stop”
		position.
		– Turn the dishwasher
		off using the “On/Off”
		button.
		– Check the water inlet
		filter and clean if
		necessary.
The indicator light	The incoming water has	– Start the program
“Intake/Drain” comes on	not reached the minimum	again.
during the “Energy	required temperature of	– If the indicator light
Saver” program	115° F (45 °C), the hot	comes on again select
	water system may be	a different program.
	overloaded (see “Pro-
	gram selection”).

45