WARNING: An electrical short in the back box may occur if the metal BNC connector is not completely covered by the protective boot.
4.Connect wiring to the circuit board inside the back box. When finished, close the door to the back box and turn on the power. The green LED will light.
NOTES:
•Aux 1: Maximum 2 A at low voltage (<40 V)
Aux 2: Maximum 30 mA at 32 VDC
•If you are using both unshielded twisted pair (UTP) wiring and a translator board, install the UTP wiring before installing the translator board.
•If you are installing an environmental back box in a railway application, attach a ground wire from the circuit board power connector to a structural ground using at least
5.Attach the back box leash to the lower dome.
C3418M (8/06) | 5 |
