LOCATION AND FUNCTION OF PARTS
Refer to Figure 1.
Lens Mount
The camera has a standard CS lens mount but can use a
Back Focus Lock Screw
Loosen to adjust the back focus to match the lens attached to the CS mount. Refer to the section on Back Focus Adjustment in this manual.
Camera Mounts
Top or bottom mounting. Maximum thread length is
Level Adjuster
Controls the video output level when using a
Lens Connector
Video Output Connector
This coaxial connector (BNC type) outputs the video signals.
Iris Mode Selector Switch
Switch to VIDEO when an auto iris lens is controlled by a video signal. Switch to DC when using a DC voltage drive lens.
LL ADJ Switches
Use switches to adjust the vertical phase up or down to eliminate vertical roll when multiple cameras are connected to a switching device. Each cameraÕs output is synchronized to the frequency of the power supply.
AGC – Automatic Gain Control
Automatically adjusts the image to compensate for changes in light levels. The AGC function switch can be turned ON/OFF by moving the AGC switch right or left. AGC is factory set to ON.
ESC – Electronic Sensitivity Control
This function changes the sensitivity of the camera by varying the electronic shutter speed according to the amount of incident light. The ESC range is 1:300. To reset the ESC function switch, move the ON/OFF switch right or left. The ESC is factory set to the ON position.
BLC – Backlight Compensation
The backlight compensation function allows fine picture correction to prevent the subject from being extremely dark due to strong backlight. The BLC function switch can be turned ON/OFF by moving the BLC switch right or left. The BLC is factory set to the OFF position. Set the AGC switch to ON when using the BLC function.
6 |
