8.Change the field labeled Flow control to None. Click OK.
7
8
9.You are now ready to configure PelcoNet. Hold the Shift key and press the ? key. This brings up the Help menu.
10.Press the I key to set the IP address. Type the new IP address PelcoNet will be using on the network. Press Enter.
11.Press the S key to set the subnet mask. Type the new subnet mask. Press Enter.
12.Press the G key to set the gateway IP address. Type the new gateway IP address. Press Enter.
9
10
11
12
13. Close HyperTerminal. If prompted to save settings, click OK.
9 |
