Pelco C2227M-D, PMCL-CMP important safety instructions Pmcl-Cmp

C2227M-D (8/07)

PMCL-CMP

Monitor Mount and Telescoping Pole

Important Safety Instructions

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Installation should be done only by qualified personnel and conform to all local codes.

6.Only use installation methods and materials capable of supporting four times the maximum specified load.

7.Only use replacement parts recommended by Pelco.

8.This unit is designed for indoor use only, and it must not be installed where exposed to rain or moisture.

Description

The PMCL-CMP is a ceiling mount and pole that can be used to mount any of Pelco’s 200, 300, or 400 Series flat panel LCD monitors. This mount can also support most sizes of Pelco’s 500 Series LCD monitors, although a PMCL-V100, PMCL-V200, or PMCL-VA adapter plate may be required. The PMCL526 monitor requires the PMCL-V100 adapter and the PMCL532 monitor requires the PMCL-V200 adapter; the adapters are included with the corresponding monitors. The PMCL537 and PMCL542 require the PMCL-VA adapter (not included).

The PMCL-CMP mount can be swiveled 360 degrees to allow you to use your monitor in either landscape or portrait view. The mount also allows you to tilt the monitor 35 degrees for the best viewing angle. The pole telescopes from 15 to 30 inches. This mount can also be used with Pelco’s MRCA ceiling mount. The PMCL-CMP is capable of supporting a maximum load of 90 pounds (40.8 kg).

NOTE: If you are installing a mount using a Pelco adapter (PMCL-V100, PMCL-V200, or PMCL-VA), refer to the manual shipped with the adapter for installation instructions.

Installation

The following parts are supplied:

Qty Description

1Mounting flange

1Mounting head

1Telescoping pole

4M4 x 10 mm pan head Phillips screws, stainless steel

4Split lock washers

4M6 x 12 mm pan head Phillips screws, stainless steel

4Flat washers

1Allen wrench, 3/16-inch

1Allen wrench, 3/32-inch

To install the ceiling mount:

NOTE: It is recommended that two people be present when mounting the monitor. One person should hold the monitor, while the second person installs the screws to secure the monitor to the mount.

1.Attach the mounting flange to the ceiling. (Mounting hardware is not supplied.)

a.If installing the mount to a wood beam ceiling, the beam must be at least 2 inches x 4 inches with a maximum 0.5-inch thick layer of plasterboard. Use the following steps to attach the mounting flange to a wood beam ceiling:

(1)Use a stud finder to locate and mark the edges of the wood beam that the mount will be attached to.

(2)Center the mounting flange between the edges of the beam. Use the mounting flange as a template to mark two mounting holes that are not adjacent to each other.

(3)Attach the mounting flange to the ceiling using two 1/4 x 2-inch wood screws as shown in Figure 1 on page 2.