Removal
1. Place the monitor face down, being careful not to scratch or touch the screen.
NOTE: Disconnect the monitor from the power source before removing and replacing the camera. 2. Use the thumbscrew on the bottom of the monitor to open the access door, refer to Figure 2.
Figure 2. Access Door
3.Unscrew the three metric screws (14 mm) that secure the camera. Remove the screws and spacers.
4.Gently pull the camera out of the monitor, being careful not to damage the attached connection leads. Detach the two camera connection leads from the camera
DIP Switch Settings
Set the DIP switches on the replacement camera before installing it in the PVM.
1.Locate the DIP switch.
2.Set the switches for your installation using a small screwdriver, refer to Figure 3.
Figure 3. DIP Switches
C2948M (5/08) | 7 |
