DESCRIPTION
The RK100 Rack Mount Kit provides rack mounting for the QD104 Series Quad Video Processor while the RK101 Rack Mount Kit does the same for the DX2000DH Data Hub. The RK100 and RK101 are similar except for minor differences in dimensions and the location of screw holes. These kits support the mounting of one or two units per rack.
INSTALLATION
The RK100 and RK0101 rack mount kits contain the following parts:
QtyDescription
1V bracket
1Mounting block
2Short rack ear
1Long rack ear
4Screw,
4Screw,
Single Mount
To rack mount one QD104 Series Quad Video Processor or one DX2000DH Data Hub, refer to Figure 1. (Only the quad is shown in the drawing. Installation of the data hub is similar.) Do the following:
1Remove the front and center screws from both sides of the unit’s cover. Use two of the screws and attach the short rack ear to either the left side or right side (illustration shows installed on left side) of the unit.
2Use the remaining two screws and attach the long rack ear to the opposite side (illustration shows installed on right side) of the unit.
3Use the four black, Phillips, pan head screws (supplied) and mount the assembly to the rack.
1
2
3
3
Figure 1. Single Mount (Quad Unit Shown)
[ 2 ] Pelco Manual
