24 Pelco Manual C650M (12/98)
• REPEAT – Rewinds the tape to the beginning and re-
sumes recording.
• ALARM•PROT – (Alarm Protection) If alarm recordings
are on the tape, then the tape stops. “End” appears on
the fluorescent display and “Tape End” on the monitor.
When CALL OUT is set to WRNG•TAPE END, a call sig-
nal is output from the CALL terminal. If there are no alarm
recordings, the tape is rewound and recording continues.
QUASI V-SYNC Sets Quasi V-Sync on or off.
• ON – Quasi V-Sync signal is inserted on the video output
signal when in the special playback modes (still, slow
motion, reverse, fast playback, speed search) and during
normal playback in L12H, 12H, L24H, or 24H modes.
• OFF – Quasi V-Sync signal is not inserted.
TIME DATE Sets the time, date, and Daylight Savings setting. Section 6.9.1
ADJUST provides an explanation while Section 6.9.2 provides a proce-
dure.
6.9.1 Day and Time Display ModesDISPLAY MODE 1
1. Month-Day-Year
2. Hour:Minute:Second
3. Daylight Savings Time symbol or power failure symbol
4. Alarm recording number
• A 24-hour display is used: 00:00 indicates midnight; 12:00, noon; and
15:00, 3 p.m.
• An alarm recording number is displayed during alarm recording.
DISPLAY MODE 2
1. Month-Day-Year
2. Day of the week
3. Alarm recording number
4. Hour:Minute:Second
5. Daylight Savings Time symbol or power failure symbol
6. Recording mode
• A 24-hour display is used: 00:00 indicates midnight; 12:00, noon; and
15:00, 3 p.m.
• The day of the week is automatically set.
• An alarm recording number is displayed during alarm recording.
NOTE:
Some multiplexers may re-
quire Quasi V-Sync OFF to work
properly. With the Pelco MX4000
Series Genex™ Multiplexer, setting
Quasi V-Sync on or off has no ap-
parent effect on playback.
Figure 14. Display Mode 1
Figure 15. Display Mode 2
01-01-97 00:00:00 A0001
01-01-97 WED A0001
00:00:00 L24