Pella 801U0103 Securing The Window, Installation Clip Method, Interior Seal, Proceed to Step

HURRICANESHIELD WINDOWS Ř

4SECURING THE WINDOW

A.Install a #10 x 3-1/2" corrosion resistant wood screw into each pre- drilled screw hole.

Note: Minimum 1-1/4" embedment into the wall framing is required.

Proceed to Step 6.

	#10 x 3-1/2"
	corrosion
5A	resistant
4A	wood screw

ŘA L L W I N D O W S Ř A L L W I N D O W S Ř Ř  PERFORMANCE UPGRADE &

5INSTALLATION CLIP METHOD

A.Fasten the window to the opening by driving two

#6 x 1-1/2" or longer corrosion resistant screws into
the pre-punched holes in the clips. If clips are bent and
fastened to the interior stud/block, install the screws as
close to the bend as possible.	5A6A
Note: DO NOT shim above the window.

6INTERIOR SEAL

Caution: Ensure use of low pressure polyurethane window and door insulating foams and strictly follow the foam manufacturer’s recommendations for application. Use of high pressure foams or improper application of the foam may cause the window frame to bow and hinder operation.

A. Apply insulating foam sealant. From the interior, insert
the nozzle of the applicator into the space between the
window and the rough opening approximately 1" past
the edge of the frame (and past the jamb extensions)
and apply a 1" deep bead of foam. This will allow room
for expansion of the foam and will minimize squeeze
out. Apply sealant across the interior surface of the
shims to create a continuous seal. Follow foam
manufacturer's instructions.
Note: DO NOT place any foam between jamb	{
	6A
extensions and the rough opening.

Note: DO NOT completely fill the space from the back of the fin to the interior face of the opening.