Pella 80WW0101 Exterior Finish Of Existing Frame, Exterior Finish Of Aluminum Clad Windows

EXTERIOR FINISH OF EXISTING FRAME

The exposed wood and flashing tape on the exterior stop needs to be covered/protected. There are many ways to accomplish this, and each case can be unique.

A few possibilities include:

a) Covering the existing trim with aluminum coil wrap/ frame expander.

b) Sanding, priming and painting to match existing trim.

c)Covering the exposed wood with a high quality exterior grade sealant.

Note: The contractor/installer will determine how to finish the exterior.

EXTERIOR OF WINDOW

WITH FRAME EXPANDER

EXTERIOR FINISH OF ALUMINUM CLAD WINDOWS

The exterior frame and sash are protected by aluminum cladding with our tough EnduraClad® or EnduraClad Plus baked-on factory finish that requires no painting. Clean this surface with mild soap and water. Stubborn strains and deposits may be removed with mineral spirits. DO NOT use abrasives. DO NOT scrape or use tools that might damage the surface.

Use of inappropriate solvents, brickwash or cleaning chemicals will cause adverse reactions with window and door materials and voids the Limited Warranty.

INTERIOR FINISH

If products cannot be finished immediately, cover with clear plastic to protect from dirt, damage and moisture. Remove any construction residue before finishing. Sand all wood surfaces lightly with 180 grit or finer sandpaper. DO NOT use steel wool. BE CAREFUL NOT TO SCRATCH THE GLASS. Remove sanding dust.

Pella products must be finished per the below instructions; failure to follow these instructions voids the Limited Warranty.

•On casement and awnings, it is optional to paint, stain or finish the vertical and horizontal sash edges.

•On single-hungs and double-hungs, do not paint, stain or finish the vertical sash edges; any finish on the vertical sash edges may cause the sash to stick. It is optional to paint, stain or finish the horizontal sash edges.

•On patio doors, it is optional to paint, stain or finish the vertical and horizontal panel edges.

Note: To maintain proper product performance do not paint, finish or remove the weather- stripping, mohair dust pads, gaskets or vinyl parts. Air and water leakage will result if these parts are removed. After finishing, allow venting windows and doors to dry completely before closing them.

Pella Corporation is not responsible for interior paint and stain finish imperfections for any product that is not factory-applied by Pella Corporation. Use of inappropriate finishes, solvents, brickwash, or cleaning chemicals will cause adverse reactions with the window and door materials and voids the Limited Warranty.

For additional information on finishing see Pella Owner’s Manual or go to www.pella.com.

CARE AND MAINTENANCE

Care and maintenance information is available by contacting your local Pella retailer. This information is also available at www.pella.com.