![](/images/new-backgrounds/1053820/5382013x1.webp)
3 SETTING AND FASTENING THE DOOR (continued):
CLIP OR FRAME SCREW INSTALLATION, GO TO STEP 5I.
G. Fasten the door to opening by |
|
driving |
|
into each |
|
nailing fin. | 3G |
Note: Make sure the fin corner is lying as flat as possible
H.Carefully open the door(s) and remove all shipping spacers.
Note: Be sure to remove the spacers from the bottom edge of the door panel.
Exterior
3I
Exterior
3I
Door with brickmould
and nail fin
Door with
nail fin only
Double Doors with Multipoint latch in center: Use the construction handle to operate the active door handle. Operate the flushbolts per the instructions on the label on the strike located on the astragal.
I.Designer Series®
All other doors: Sill screws are not needed.
For combinations
J.For Low Profile Sills: through each installation screw hole drill a 1/8" pilot; and install a #8 x 3" corrosion resistant screw (provided) into the pilot hole into the floor. For doors including a standard lock install tubs per instruction included with the sill strike package.
Note: For concrete floors use masonry screws that are a minimum size of 3/16" diameter x 3" and pilot per manufacturer’s recommendations for the screw.