Pella V983492 CLEANINg INSTRUCTIONS, Important Notice, OPTIONAL SILL PAN fABRICATION

10 OPTIONAL SILL PAN fABRICATION

AND INSTALLATION (CONTINUED)

Install the sill pan into the opening, aligning the interior and exterior edges with the pencil marks from previous illustration. Press down on the sill pan to seal it into the opening.

Place one 1/4” diameter bead of sealant in the following locations:

-In the bend at the back of the sill pan.

-1/2” from the exterior edge of the sill pan.

-Midway between the interior and exterior beads of sealant.

-Leave a 2” sealant gap at teach end of the two exterior lines of sealant for drainage.

Sealant between the back and side legs of sill pan

Leave gap at each end of sealant lines

Also seal the joint between the back and side legs of the sill pan with sealant.

Return to Step 2

CLEANINg INSTRUCTIONS

Remove labels and clean the glass, using a soft, clean, grit-free cloth and mild soap or detergent. Be sure to remove all liquid by wiping dry or use a clean squeegee. The vinyl frame may be cleaned as described above. For stubborn dirt, a "non-abrasive" cleaner such as Bon-Ami® or Soft Scrub® may be used. DO NOT use solvents such as mineral spirits, toluene, xylene, naphtha or muriatic acid as they can dull the finish, soften the vinyl and/or cause failure of the insulated unit seal. Keep door tracks clear of dirt and debris. Keep weep holes open and clear of obstructions.

IMPORTANT NOTICE

Because all construction must anticipate some water infiltration, it is important that the wall system be designed and constructed to properly manage moisture. Pella Corporation is not responsible for claims or damages caused by anticipated and unanticipated water infiltration; deficiencies in building design, construction and maintenance; failure to install Pella® products in accordance with Pella installation instructions; or the use of Pella products in wall systems which do not allow for proper management of moisture within the wall systems. The determination of the suitability of all building components, including the use of Pella products, as well as the design and installation of flashing and sealing systems are the responsibility of the Buyer or User, the architect, contractor, installer, or other construction professional and are not the responsibility of Pella.

Pella products should not be used in barrier wall systems which do not allow for proper management of moisture within the wall systems, such as barrier Exterior Insulation and Finish Systems, (EIFS) (also known as synthetic stucco) or other non-water managed systems. Except in the states of California, New Mexico, Arizona, Nevada, Utah, and Colorado, Pella makes no warranty of any kind and assumes no responsibility for Pella windows and doors installed in barrier wall systems. In the states listed above, the installation of Pella products in barrier wall or similar systems must be in accordance with Pella installation instructions.

Product modifications that are not approved by Pella Corporation will void the Limited Warranty.

V983492

Page-16