Reference:

The above table is the 6 possible combination of each recording pixels and quality setting.

How to set the Flash?

The Flash Mode can only be set under CAPTURE mode. There are 4 modes available: Auto, Red-Eye, Flash ON and Flash OFF. The default setting is Auto. To change the setting, press the Mode button a number of times until the desired one is selected.

Mode

Description

Auto

Flash is enabled automatically in low

 

light conditions

Red-Eye Auto Mode with Pre-Flash to reduce red eye effect

Flash ON Flash is always enabled

Flash OFF Flash is always disabled

￿The setting is conserved even if the camera power is off.

The flash effective range is 0.4m - 2m (1.3feet - 6feet).

Advanced Operation

How to adjust the EV compensation?

To adjust the EV compensation, perform the following:

1.Set the operating mode to CAPTURE .

2.Press the MENU button. The Capture menu appears.

3.Select the EV COMPENSATION item by the arrow buttons (￿/￿) and then press the OK button to confirm.

4.Use the arrow buttons (￿/￿) to select the

desired exposure value.

*The effective range is from -2.0 to +2.0 in steps of

0.3EV.

5.Press the OK button again to make the change. The cursor returns to the CAPTURE MENU.

￿This setting is reset to 0.0 when the camera power is off.

How to adjust the White Balance?

To adjust the White Balance, perform the following:

1.Set the operating mode to CAPTURE .

2.Press the MENU button. The Capture menu appears.

13