Perlick DC90ACLT Installation and Tapping ArctiCold Draft Dispenser, Priming the Beer System

Installation and Tapping ArctiCold Draft Dispenser

Tapping a Single Valve Keg (Sankey)

■Be sure beer faucet is in closed position.

■Align keg lugs with lug openings on bottom of coupler.

■Turn clockwise 1⁄4 turn. Pull handle out and down. Keg is now tapped.

■Open shut-off valve on CO2 distributor located inside of the cabinet.

Important: Be sure to close this valve when untapping keg.

CAUTION: Do not use keg coupler as a handle to lift keg.

Priming the Beer System

■Plug in top refrigeration deck, (15-amp plug), and allow condensing unit to cycle at least once, (circulation pump will run continuously), before tapping the keg.

■Couple beer keg to system. Beer temperature in keg should not exceed 42°F.

■Apply 14-17 PSIG carbon dioxide gas.

■Open faucet and pour for approximately 15 seconds.

■Close faucet and wait for at least 15 minutes to allow beer system to “pack”.

■You are now ready to tap beer.

Step 1

Single Valve Keg Coupler

Step 3

Step 2

1/4

TURN

OUT

DOWN

	Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
Form No. Z2323	4
Rev. 06.26.10