Perlick DC90ACLT Preventative Maintenance ArcticCold Draft Dispenser, Cleaning the Condenser

Preventative Maintenance ArcticCold Draft Dispenser

Cleaning the Condenser

The condensing coil should be inspected before each operation and cleaned if necessary. The condensing coil can be accessed by removing the louvered cover located on the customer side of the cabinet. The coil can be adequately cleaned with a vacuum, stiff bristled brush, or forced air. Please use care to ensure that the fins of the condenser are not bent or damaged.

Glycol Level

The glycol system should be checked before each operation to ensure an adequate level. The glycol reservoir can be accessed by removing the lou- vered cover on the refrigeration deck. The reservoir is located at the right rear of the deck, (see figure A). Remove the sponge insulation and unscrew the cover. While using a mirror, ensure the glycol level is at the visible seam inside the reservoir located approximately 2" below the threads. Contact the Perlick Corporation for proper glycol solution if needed.

Pump Motors

Sleeve-bearing pump motors should be oiled at least once per year, (see figure A).

Casters

The casters should be greased at least once every 6 months. This may be required more often if the unit is used in dusty environments. There is a grease fitting located on each caster.

92 3/4”

26 1/2” 24 3/4”

91”

53 3/8”

43 1/16”

	Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
Form No. Z2323	10
Rev. 06.26.10