Petsafe pbc12104 manuel dutilisation Do’s and Don’ts, Inserting the battery, Turning on the device

Inserting the battery

The battery compartment is on the same side as the fill-up valve (N). Remove the battery cover by twisting it and insert the 3-volt battery (the + end first) (O). Twist the cover back on (a coin can be used to help you remove and put back the cover) (P).

N

O

P

Note: If the red light flickers three consecutive times, the collar battery is low and needs to be changed.

Turning on the device

To turn on the device, press the grey button on the front of the device	Q
(Q). The green light will flash once, indicating the power is on; the green
light will flicker every few seconds.Your device, already preset in short
spray mode, is now ready to function. To change to a longer spray, press
the same grey button once. The green light will flash twice to confirm the

new spray setting. To go back to the shorter spray, press the button

once again. The green light will flash once to confirm the change.You can switch spray settings at will by simply pressing the grey button.

Turning off the device

To turn off the device, press the grey button until the red light flashes twice. The green light will no longer flicker.

Note: Before every use, it is best to test the device by blowing into the microphone.

Adjust the spray collar onto the dog’s neck with the on/off button facing outward and the fill-up valve and battery cover facing downward (R).

Your Anti-Bark Spray Collar™ will now react when your dog barks. Training, in addition to the use of the device, will accelerate and consolidate the desired behavior (behaviour) modification.

R

Do’s and Don’ts

•The collar should be worn only during periods of nuisance barking and no more than eight hours per day.

•The collar must be filled to maximum capacity before placing it around your dog’s neck.

•Never fill the device while your dog is wearing it because it may damage the fill-up valve.

•To ensure that your dog does not make the connection between you and the spray collar, don’t let him see you prepare the device, neither for the first try, nor for subsequent use. Keep your dog away while you prepare the device as well as when you fill it or change the battery. A B C

•It is important that your dog’s hair doesn’t block the spray valve.Try tying a bandanna (handkerchief) around your dog’s neck, then place the spray collar over. If necessary, you may also consider trimming a little of the long hair around the dog’s throat for better spray effect.

•Remove all other collars with metallic parts or tags.These could create noise that may needlessly activate the spraying device.

•Never fasten a leash (lead) to the Anti-Bark Spray Collar.

•Avoid letting your dog wear the device with an empty reservoir. Make sure it is always full.

•Turn OFF the device while not in use.

•The system should only be used with pets who are over 6 months of age. If your pet is injured or its mobility is otherwise impaired, contact your veterinarian or professional trainer before use.

4 www.petsafe.net