PGS A Series, A-30, A-40 14)

Stainless Steel Column (A-S PED)

1. Attach the grill head bottom to the pedestal

column top with four ¼ - 20 x1 ½" Hex bolts,

washers under the bolt head, reinforcing bar and

Kep nuts. Note Reinforcing Bar used on the A-B

PED Aluminum Column.

OPTION: For Portable Base Only A-LC & A-NC: (Fig. 12)

1. Attach the wheels by slipping the axle through the base,

slide the wheels on and secure with the axle clips.

Finish by snapping the hubcaps on before standing unit

upright. For units with casters, place caster stem into

stem opening of the portable base, press and snap into

place. (Fig. 12)

Aluminum Column (A-B PED)

Fig 13A

Step 4: Attaching the Access Panel (Fig.

14)

Note: Do not attach the front access panel until the control

panel has been attached to the grill head bottom

and the gas supply line has been properly

connected and leak tested.

1. The front access panel attaches directly under the

control panel and hides the access opening. Lift the

access panel up behind the lip of the control panel,

then slip the bottom double edge of the access panel

(upward pressure may be needed) over the edge of the

access opening.

(Fig. 13)

1. Attach the grill head bottom to the pedestal column top

with four

¼ - 20 x1 ½" Hex bolts, washers under the bolt head and Kep

nuts. Peel the remaining protective coating off the pedestal

column.