9
GRILL MOUNT: Supports gas grill head, can be a
post and base mount, a permanent post mounts
pedestal mount (stationary or mobile) or built in frame
inserted in a masonry enclosure.
COLUMN; Pedestal that support grill head when
used with a base kit. Ours are either stainless steel of
aluminum.
GRILL UPPER CASTING: Top (lid) of gas grill head,
made of aluminum and powder coated black.
GRILL LOWER CASTING: Bottom (pit) of gas grill
head made of aluminum and powder coated black.
BASE: Stationary or designed to be used with wheels
made of aluminum and powder coated black.
VALVE: Device used to control amount of gas (and
heat) grill produces.
ORIFICES: Openings at end of valve that restrict
amount of gas going to BBQ.
VENTURI: Banana shaped tube that allows gas to
flow from the valve to the burner.
FEEDLINE: Aluminum gas line from back to grill
mount to bottom of valve. Used only on models that
include pedestal.
HINGE PINS AND COTTER PINS: Hinge pin goes
through lower and upper casting with cotter pins
permanently holding.
GASKET: Insulator between pedestal and base.
WATER COLUMN (W.C.): A measurement of gas
pressure.
YOU WILL NEED THE FOLLOWING TOOLS TO ASSEMBLE YOUR PGS GAS GRILL:
1 - Mallet or Hammer 1 - Med. Phillips Head Screw Driver
2 - 6" Adjustable Wrenches 1 - Small Roll of Teflon Tape (Natural Gas Only)
50% Soap and Water Solution 1 - Spray bottle or brush
Having these additional tools on hand will make assembly easier:
1 - 1/2" Socket and Drive 1 - 7/16" Socket and Drive
REF# MISC HARDWARE QTY PART NUMBER AA SIDE SHELF BOLTS 7/16 x 1/4/20 x .75" 4 190170 AB CONTROL PANEL HEX BOLTS 7/16 x 1/4/20 x .75" 2 190170 AC HEAD HEX BOLTS 7/16 x 1/4/20 x 1.25" 4 190050 AD BASE HEX BOLTS 1/2 x 5/16 x 3/4 6 190010 AE STIFF BRKT / HEAD BOLT 1/4 x 20 x 1.25" 2 190050 AF STIFF BRKT / PANEL BOLT 1/4 x 20 x .5" 2 B1401 BB FLAT WASHER 5/16" 6 190020 BC LOCK WASHER 5/16" 6 190030 CA NUT 1/4 LOCKING KEP 10 N1404 CB NUT 5/16 6 190040
Hardware is not pictured