PGS A Series, A-30, A-40 (Fig. 25)

Connect the 30" flexible tube to the incoming gas supply using a 3/8" flare coupling (not supplied). Attach the other end to the grill valve connection behind the control panel. To tighten securely use two wrenches. Hold valve joint with one wrench and tighten the hose fitting with second wrench. After Tighten leak test both connections. See Leak Testing

DO NOT USE COMPOUND

OR TEFLON TAPE ON

FLARE FITTINGS

IGNTIOR ASSEMBLY

Stainless (A-S PED) and

Aluminum (A-S PEDB)

Column Mounts:

The supply line connection passes beneath the heat shield and through the front slot with the protected edge and attaches to the valve. Don’t forget to attach the front Access Panel to the Column.

PGS uses the finest electronic ignition available.

Normal use will need to replace battery every six

months, or whenever sparking sound gets weak or

stops. To replace battery, simply unscrew cap found

on top of control just below the word “Ignitor).

Replace with a fresh AAA battery.

If ignitor does not produce a spark with a fresh

battery, make sure that ignitor wire is plugged into

back of ignitor as shown in Figure 21 on page 16 and

also wire in securely plugged into ignitor box in figure

37 on page 20. NOTE: Replace battery when

sparking sound either stops or noticeably slows down

or every six months, whichever occurs first. If you are

not going to use your grill for more than 30 days,

remove the battery. Reinstall when you are ready to

use your grill again.

(Fig. 25)

LP Propane for portable base and

deck/patio mounts:

The hose connection from the Regulator passes out the front access opening; resting on the protected slot edge beneath the control panel. The LP tank-locking bar will press against the tank as it is lowered into place to prevent tank movement. (Fig. 26)

SIDE SHELF ASSEMBLY

Install the left and right shelf brackets to the lower

casting of your barbecue, using the four 1/4 X 20 X

3/4" hex bolts, secure with four 1/4" lock washes and

four 1/4" hex nuts to hold each bracket (see Fig. 9).

Attach shelf to the brackets by inserting the threaded

screws on the shelf through the lower slots on the

brackets. Let the shelf hang down. Attach the 10-32

Hex Nuts (see Fig. 30).

Natural gas for deck/patio mount:

The gas line enters at the rear of the

base curving up through the base

opening. The stainless steel flexible

tubing line must be connected to the

incoming gas line using a 3/8" flare

coupling (not supplied by PGS). The

flexible tubing then passes beneath the

heat shield and through the front access

opening and attaches to the control

valve. (Fig. 27)

See tube-bending instructions

Page 24 Figure 49.

Figure 30 Installing Shelf Bracket

On portable models, this shelf, in the upright position,

is to be used as a handle to move the barbecue

Natural gas or LP portable base

mount:

The natural gas cart uses a 12 foot

hose with a quick disconnect

(supplied), the propane uses a 16”

ose

with LP R

egu

r. Th

ose