R
T E C H N O L O G Y
Installation Instructions: Installing the
1. Unpack speaker. Leave | 2. Use hole template to | 3. Use RotoZip or other tool |
paint mask in place until | mark cutout on sheetrock. | to cut hole. Hole diameter: |
after speaker is installed or |
| 5.6 in. (142 mm). |
painting is complete. |
|
|
5. If required, attach seismic | 6. Insert speaker into | 7. Remove paint mask |
restraint system to hole in | mounting hole with paint | unless painting is required. |
clamping arm, then to | mask in place. Tighten both | In that case, follow steps |
reinforced structure (safety | screws on the baffle face to | |
cable not included). | actuate the mounting wings. | complete. |
| Firmly secure both screws, |
|
| DO NOT OVERTIGHTEN. |
|
1. |
|
|
2. |
|
|
9. Attach grille safety clip by | 10. Align tabs on | 11. Done! |
placing the large end of the | grille with slots in baffle, |
|
clip over | gently press grille into place. |
|
then sliding clip until small |
|
|
end snaps into place around |
|
|
post (2). |
|
|
4.Connect Euroblock to speaker wires, and connect to speakers.
8.Adjust tap switch to proper setting. Switch is preset to