Phase Technology CL-1.5 Finish installing ceiling, Use RotoZip or other tool to cut hole

R

T E C H N O L O G Y

Installation Instructions: Installing the CI-1.5 Using Optional Pre-Construction Bracket

1.Nail or screw bracket to joists.

5.Connect euroblock to speaker wires, and connect to speakers.

2.Finish installing ceiling.

6. If required, attach seismic restraint system to the sheet-metal tab on the rear panel of the speaker, then to reinforced structure (safety cable not included).

1.

2.

3.Use RotoZip or other tool to cut hole.

7.Insert speaker into mounting hole. Tighten both screws on the baffle face to actuate the mounting wings.

DO NOT OVERTIGHTEN.

4.Unpack speaker. Leave paint mask in place until after speaker is installed or painting is complete.

8.Remove paint mask unless painting is required. In that case, follow steps 9-12 when painting is complete.

9.Adjust tap switch to proper setting. Switch is preset to the 8-ohm mode.

10. Attach grille safety clip	11. Align tabs on snap-fit
by placing the large end of	grille with slots in baffle,

the clip over snap-fit post (1), gently press grille into place. then sliding clip until small

end snaps into place around post (2).

12.Done!