Phase Technology V-3.0 Model Tweeter Midrange Woofer Frequency, T-V3.0 1” SOFT DOME, Satin Black

Models: PC-3.0 V-3.0

1 4
Download 4 pages 38.14 Kb
Page 4
Image 4
MODEL
SPEAKER MOUNTING BRACKET
Step 7LOCKING SCREWS IN
The EVT™ switch which is located on theSPEAKER BRACKET front of the speaker under the grille activates
Phase Technology’s Enhanced Voice
Technology feature. This feature is designed to improve the clarity of the voice or dialogue from the center channel speakers in the system. Flipping the switch to the “UP position engages the circuit and “DOWN” turns it off.
MOUNTING TO FLAT PANEL MOUNTING BRACKETS
There are additional mounting inserts on the rear of the speaker cabinet to facilitate attaching the sound bar speakers to on wall flat panel mounts, see note figure 1. There are 6 threaded inserts provided that coincide with the requirements of most manufactures mounts. Please check with your mount manufacture for applications and compatibility.
TEATRO SOUND BAR SPEAKER SPECIFICATIONS
WALL MOUNTING BRACKET

Adjust the rubber stand-off bumpers by turning them either in or out to adjust the tilt of the speaker until the front is vertical. Lock the adjusting screws in place by tightening the locking nuts against the rear of the cabinet. Please be certain that the nylon washer is between the nut and the cabinet to protect the cabinet finish.

Step 6

Since the TEATRO sound bar speakers form the front 3 speakers in a home theater system for flat panel displays they are to be used and set up as you would any normal 5.1 to 7.2 surround sound system for balance and level adjustments. The amplifier should be set to the small speaker mode for the left/center/right front speakers for the best performance. The subwoofer setting should be set to 80 Hz. We recommend the use of our Phase Technology subwoofers and surround speakers for complimenting your installation.

FIGURE 3

LEVELING ADJUSTMENT

SCREW IN WALL BRACKET

MODEL

TWEETER

MIDRANGE

WOOFER

FREQUENCY

SENSITIVITY

IMPEDANCE

MAXIMUM POWER

T-V3.0

1” SOFT DOME x 3

-----

5.25” VDT x 3

55Hz-22kHz

91dB

4 OHMS

120 WATTS

T-PC3.0

1” SOFT DOME x 3

1.5” SOFT DOME x 3

5.25” RPF x 3

52hz-22kHz

89dB

4 OHMS

150 WATTS

DIMENSIONS

FINISH

WEIGHT

40” (W) x 7” (H) x 4 ½” (D) (5 ½” with bracket)

SATIN BLACK

GLOSS BLACK

 

 

 

 

25 LBS

30 LBS

 

 

218-2082

Page 4
Image 4
Phase Technology V-3.0 Model Tweeter Midrange Woofer Frequency, Sensitivity Impedance Maximum Power, T-V3.0 1” SOFT DOME