XP AZ 1018/17
English
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.
Problem | Solution |
|
No sound | – Adjust the VOLUME | |
|
|
|
No power | – Power cord not securely connected. Connect AC | |
| power cord properly | |
| – Batteries dead /incorrectly inserted. Insert (fresh) | |
| batteries correctly | |
|
|
|
Display does not function | – Electrostatic discharge | |
properly/ No reaction to | Switch off and unplug the set. Reconnect after a few | |
operation of any of the | seconds. | |
controls |
|
|
|
|
|
no d1SC, Cd Err or | – No CD inserted, insert a CD | |
nF d1SC indication | – CD badly scratched/ dirty. Replace/ clean CD (see | |
| maintenance) | |
| – | |
| Use a finalized | |
| – Laser lens steamed up. Wait until lens has acclimatized | |
|
|
|
Laser lens steamed up | – Wait until lens has cleared | |
| – Wait until lens has acclimatized | |
|
|
|
CD playback does not work | – CD badly scratched/ dirty. Replace/ clean CD (see | |
| maintenance) | |
|
|
|
The CD skips tracks | – CD damaged or dirty. Replace or clean CD. | |
| – Program is active. Quit program mode | |
|
|
|
Poor cassette sound quality | – Dust and dirt on the heads, etc. | |
| Clean deck parts, see maintenance. | |
| – Use of incompatible cassette types (METAL or | |
| CHROME). Only use NORMAL (IEC I) for recording | |
|
|
|
Recording does not work | – Cassette tab(s) may be broken. Apply a piece of | |
| adhesive tape over the missing tab space. | |
16
