XP AZ 1018/17
Power Supply
Batteries contain chemical substances, so they should be disposed of properly.
Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst.Therefore:
•Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.
•When inserting new batteries, do not try to mix old batteries with the new ones.
•Remove the batteries if the set is not to be used for a long time.
Using AC Power
1Check if the power voltage, as shown on the type plate located on the bottom
C MAIN | S ~ |
A |
Switching power on/off:
Save energy
Whether you are using mains or battery supply, to avoid unnecessary energy consumption always adjust the POWER slider to TAPE/OFF and check if the cassette keys are released.
AZ1018 |
VOLUME |
BATT |
LOW |
PLAY- |
PAUSE |
STOP |
CDMODE |
PROGRAM |
FM•AM |
SE |
AR |
CH |
PRESET |
General operation
1To select your sound source adjust the POWER slider to CD, RADIO or TAPE/OFF.
2Adjust the sound with the VOLUME and DBB (Dynamic Bass Boost) controls.
3To switch off the set, adjust the POWER slider to TAPE/OFF position and check the cassette keys are released.
English
of the set, corresponds to your local
Note:When the set is switched off the tuner presets will be retained in the set’s memory.
power supply. If it does not, consult your dealer or service center.
2Connect the power cord to the AC MAINS inlet and the wall outlet.The power supply is now connected and ready for use.
3To switch off completely, unplug the power cord from the wall outlet.
•Unplug the power cord from the wall outlet to protect your set during heavy thunderstorms.
The type plate is located on the bottom of the set.
9
