Philips 21PV375 manual Connecting the TV-Video Combi, Important notes for operation

T6400EZ-BG/DK(EN).qx3 03.4.21 15:51 Page 4

1. Connecting the TV-Video Combi

Preparing the remote control for operation

The remote control and its batteries are packed separately in the original TV-Video Combi pack- aging. You must install the batteries in the remote control before use.

1.Take the remote control and the enclosed batteries (2 batteries).

2.Open the remote control's battery compartment and place the batteries in it as shown in the pic- ture and close the battery compartment.

The remote control is now ready to use. Its range is approximately 7 metres.

4.Language setting picture will appear on the screen.

PUSH MENU TO CONTINUE

I do not see a Language setting picture * Check the cable connections.

You can find more details in chapter 'Preparation for use'.

Connecting the cable

[14 inch]

1.Insert the aerial cable plug into the AERIAL at the back of the TV-Video Combi.

2.Connect the mains cable to the wall socket.

3.If the little red standby light (STANDBY ) at the front panel of the set is not lit, please switch on the set using the main power switch. The power switch is located on the left side panel of the set.

Connecting additional devices

You can connect additional devices such as decoders, satellite receivers, camcorders, etc. to the EXT1 socket.

[14 inch]

The respective scart socket is usually marked 'AV'or 'TV'on the decoder or satellite receiver.

2. Important notes for operation

Switching on

You can switch on the TV-Video Combi with

STANDBY/ON y .

If you press

PLAY B-K

,

STOP C-L

,

PROG P+

,

,

,

or

while

PROG P–

FWD 1- B

REW0- s

0..9

the set is in Stand-by, the power will be auto-

matically turned on.

Note that the keys

will be inactive for

0..9

about 5 seconds just after having switched the TV-Video combi off.

Power outage/no power

Channel information remains saved for up to 10 year, the time and timer information is saved for up to 1 minute.

EN

Navigation in the screen menu

You can check/change many functions and set- tings of your TV-Video Combi via on-screen menu. The individual functions are selected, via the remote control as follows:

Call up the menu: with MENU .

To select: with PLAY B-K STOP C-L .

To enter or change your selection: with the number buttons 0..9 or with PLAY B-K STOP C-LTo save or confirm: with FWD 1- B .

To cancel: with CLEAR .

To end: with STATUS/EXIT .

SELECT K L CHOOSE B

→TIMER

PICTURE CONTROL RECORD SET UP VCR SET UP TUNER SET UP GENERAL SET UP

END=EXIT

4