9. Before you call an engineer
If, contrary to expectation, you have any prob- lems using this
Your
*There is no power supply: check the power supply.
*Parental control is on:switch the parental con- trol off.
*There is a technical problem: disconnect from the mains power supply for 5 minutes, then
If this doesn't help, you can reset
Resetting devices to default factory settings *Warning: All the information stored (TV chan- nels, time and date, TIMER) will be cleared.
1.Switch the
2.Press and hold REC I and PROG P- at the same time for 2 seconds or more.
A cassette is jammed in the
Remote control does not work
*Remote control is not pointed at the
*Take out the batteries, wait for 10 seconds and place them back in the remote control. *Batteries have run out. Change the batteries.
No picture when you play a cassette
*There is no recording on the cassette.
Poor picture quality when you play a cas- sette
*The cassette is badly
*Tracking is not properly adjusted. Turn to sec- tion ‘Manual Tracking’.
*Magnetism from nearby appliances and geo- magnetism might affect the colour of the TV picture. Move the
No recording possible
*The TV channel you want to record is not stored or you have selected the wrong pro- gramme number: check TV channels stored. *A cassette was inserted that does not have the security tab (cannot be used to record): Insert a cassette with an intact security tab or change cassette. For more information, please see the section ‘Preventing accidental erasing’ in chapter ‘Manual Recording’.
*’VPS/PDC’ switched on but ‘VPS/PDC time’ wrong: enter ‘VPS/PDC time’ exactly to the minute. Check your aerial connection.
The wrong TV channel has been recorded after you programmed a recording using the SHOWVIEW system
1.Enter the SHOWVIEW programming number you wanted to record.
2.Confirm with 
.
3.Check the programme number/channel name in the ‘PROG.’ input field.
4.If this does not correspond to the desired TV channel, select the input field and change the programme number/channel name.
5.Confirm with 
.
Smart Clock does not work
*You have stored on programme number ‘P01’ a TV channel that does not transmit TELETEXT. Store on ‘P01’ a TV channel that transmits
TELETEXT.
*Poor TELETEXT reception. Store a TV channel on ‘P01’ with good TELETEXT reception.
*You have not activated the Smart Clock func- tion. Switch the function ‘ON’.
You can also call the customer service centre in your country.The telephone numbers can be found on the back of this instruction manual.
Have the model number (MODEL NO) and the production number (PROD.NO.) of your TV- Video Combi ready.
EN
17
