TROUBLESHOOTING
PROBLEM
– POSSIBLE CAUSE
• REMEDY
No sound
– Volume not adjusted.
• Adjust the volume.
MW (LW) broadcast cannot be received
properly
– Weak radio signal.
• Rotate the set for better reception and make
sure the set is placed on a non-metallic
surface.
Continuous crackling and hiss noise during
MW (LW) reception
– Interference from other electrical equipment
e.g. TV’s, computers, fluorescent lamps.
• Move the clock radio away from electrical
equipment.
Intermittent crackling sound during FM
reception
– Weak signal.
• Adjust the pigtail aerial.
The alarm does not function
– The alarm is not set
• Set the alarm time and the alarm switch to
BUZor RAD.
– Volume too low for radio.
• Increase the volume.
The slumber does not function
– RADIO still in ON position.
• Switch RADIO to OFF position.
– Clock control in TIME SET or ALARM position.
• Adjust clock control to RUN position.
All unnecessary packaging material has been
omitted. We have tried to make the packaging
easy to separate into three mono-materials:
cardboard (box), expandable polystyrene (buffer),
polyethylene (bags).
Your set consists of materials which can be
recycled if disassembled by a specialized
company. Please observe the local regulations
regarding the disposal of packing materials,
exhausted batteries and old equipment.
ENVIRONMENTAL INFORMATION
7
English
– If a fault occurs, first check the points listed below before taking the set for repair.
– If you are unable to remedy a problem by following the hints below, consult your dealer or service
centre.
WARNING: under no circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
The model and production numbers are located on the bottom of the clock radio.
This set complies with the radio interference requirements of the European Community.
CAJ3080/00 page 7