If you connect a set-top box through component video input

If the TV is connected to a cable box or satellite set-top box via component video input, make sure you select the correct component video source by using SOURCE on this unit’s remote control.

RF cable

audio L/R

set-top box

IN

OUT

IN

OUT

YPbPr

Connecting a set-top box, DVD recorder via composite connectors and analog audio

audio L/R + video

OUT

IN

 

DVD recorder

IN

 

 

OUT

 

RF IN

 

 

cable

 

 

RF IN

set-top box RF OUT

 

 

 

Do not place your recorder too close to the screen because some recorders can be susceptible to signals.

Note

Only the left loudspeaker reproduces sound for mono equipment. Use a mono to stereo adapter (not supplied) for sound reproduction via all internal loudspeakers.

When you connect cables, match the cable colors to the connectors on theTV.

4 Use your TV

English

Still mode

You can pause the image shown on the TV screen.

Press FREEZE to pause the image shown on the TV screen.

Freeze

•The sound output will not be paused.

•If no signal is detected or protected signal is received during still mode, the image remains paused and the sound output will be muted.

•The still function will be released after 5 minutes.

To cancel still mode, press any button except .(standby-On)

Watching channels from a set-top box

To watch channels from a set-top box

1 Switch on the set-top box.

»The picture from your set-top box might appear automatically on the TV screen.

2 Use the remote control of your set-top box to select channels.

If the picture does not appear

1 Press SOURCE repeatedly to select the set-top box and wait a few seconds for the picture to appear.

2 Use the remote control of your set-top box to select channels.

Watching connected devices

To watch connected devices

1 Switch on the connected device.

»The picture from your connected device might appear automatically on the TV screen.

2 Use the remote control of the device to select channels.

If the picture does not appear

1 Press SOURCE repeatedly to select the connected device and wait a few seconds for the picture to appear.

2 Use the remote control of the device to select channels.

Automatic Power Shut Off

If there is no input signal and no operation for 15 minutes, the unit will turn off automatically.

EN 7