Philips 37PF9731/69 instruction manual Connect a DVD player, a satellite receiver or Cable box

Connect a DVD player, a satellite receiver or Cable box EN

Tip: if necessary, you can adjust the picture position to the centre of the screen with the cursor keys.

AUDIO OUT		DISPLAY SYNCHRONIZED
	AUDIO		DIGITAL
R		L	AUDIO
	OUT		OUT
	AUDIO		DIGITAL
R		L	AUDIO
	IN
			IN
Y		Pb	Pr
				2
		HDTV & Progressive
EXT3		480p, 576p, 720p, 1080i
EXT3 :			EXT3 :	DIGITAL
AUDIO IN			YPbPr	AUDIO
R / L				IN
3		1

DVD / STB

With Component Video Connectors

1.Connect the three separate component video cables 1 to the YPbPr jacks on the DVD player and to the Y, Pb and Pr jacks of EXT3 on the TV.

2.Connect the audio cable 2 to the digital out of the equipment and to the DIGITAL AUDIO IN connector of the TV.

3.Select the equipment you have connected in the Installation menu, Select your connections, p. 30, and link it to EXT3. Also select Digital audio in in the same Connections menu.

4.In case of a DVD player with analogue audio, connect the three separate component video cables 1 to the YPbPr jacks on the DVD player and to the Y, Pb and Pr jacks of EXT3 on the TV. Connect the audio cable to the DVD’s audio L and R jacks and to the L/R AUDIO IN jack of EXT3 3.

5.In case of a cable box and/or a satellite receiver also connect the cable TV cable and/or the satellite antenna cable 4 and the aerial cable 5.

AUDIO OUT DISPLAY SYNCHRONIZED

DIGITAL

R AUDIO LAUDIO

OUTOUT

	AUDIO		DIGITAL
R		L	AUDIO
	IN
			IN
Y		Pb	Pr
		HDTV & Progressive
EXT3		480p, 576p, 720p, 1080i

EXT3 :EXT3 :

AUDIO IN YPbPr

R / L

3 1

DIGITAL

AUDIO

IN

2

ANTENNA

o

ANTENNA75

Notes:

- cables are often colour coded. Connect red to red, white to white, etc..;

-the labels for the component video sockets may differ depending on the DVD player connected.

CABLE	Although the abbreviations may vary, the letters
	B and R stand for the blue and red component
	signals, respectively, and Y indicates the
	luminance signal. Refer to the DVD player’s
	instructions for use for definitions and
	connection details;

- to get an optimal viewing, it is advised to switch

your equipment to the highest possible

5

supported display modes.

		Warning: in case you notice scrolling images,
	4	wrong colours or no colour, no picture, or even
		combinations of these on your screen, verify if
		the connections are done in the correct way and
		if the resolution and the signal standard of the
SAT / STB		connected equipment are set in the right way.
		See the handbook for your equipment.

Note: This television is designed to accept high definition signal standards 480p, 576p, 720p and 1080i as specified by the Electronic Industries Association standard EIA770.3.

Digital devices from different manufacturers have the possibility of differing output standards which may cause difficulties for the television to properly display.

45

Downloaded From TV-Manual.com Manuals