16ENGLISH
4 | Turn Razor Head Assembly over so that |
| underside is exposed. |
C 5 | Turn wheel of frame counterclockwise. |
6 | Remove the frame and brush clean. |
C 7 | Remove and clean one cutter and comb at |
| a time. |
Do not clean more than one cutter and comb at | |
a time, since they are all matching sets. If you | |
accidentallly interchange the cutters and combs it | |
could take several weeks before optimal shaving | |
performance is restored. | |
8 | Separate the cutter from the comb. |
C 9 | Only brush the cutter in an upward |
| motion. Use the short bristled side of the |
| brush. |
C 10 | Brush the razor head. |
For optimum performance, razor cutters and | |
combs should be cleaned in a degreasing liquid | |
(e.g. Norelco Razor Head Cleaner, model RC1776 | |
or alcohol) and lubricated with Norelco Razor | |
Lubricant, model AL80, or one drop of mineral oil | |
(in the center of the head).This helps prevent | |
wear of the shaving heads. | |
C 11 | Replace the cutter and comb into the |
| Razor Head Assembly. |
ENGLISH 17
12Repeat the process for the other two razor heads (cutters and combs).
13 | Replace the frame. |
C 14 | Turn the wheel clockwise until it locks into |
| place. |
C 15 | Replace the Razor Head Assembly back on |
| razor. |
16Put the protective razor head cap on the razor to protect heads.
After Each Use:Trimmer
1 | Turn razor OFF. |
C 2 | Push Trimmer Slide Switch up to pop up |
| Trimmer. |
C 3 | Clean Trimmer with the brush after each |
| use. |
C 4 | Lubricate the Trimmer teeth with Norelco |
| Razor Lubricant (model AL80) or with one |
| drop of mineral oil every 6 months. |
5 | Close Trimmer by sliding Trimmer switch |
| down. |
Downloaded from www.Manualslib.com manuals search engine
