Philips 7FF2FPAS manual Banned Substance Declaration, CE Declaration of Conformity

Banned Substance Declaration

This product comply with RoHs and Philips BSD (AR17-G04-5010-010) requirements

CE Declaration of Conformity

Philips Consumer Electronics declare under our responsibility that the product is in conformity with the following standards

•EN60950-1:2001 (Safety requirement of Information Technology Equipment)

•EN55022:1998/A1:2001/A2:2003 (Radio Disturbance requirement of Information Technology Equipment)

•EN55024:1998/A1:2001/A2:2003 (Immunity requirement of Information Technology Equipment)

•EN61000-3-2:2006 (Limits for Harmonic Current Emission)

•EN61000-3-3:1995/A1:2001/A2:2006 (Limitation of Voltage Fluctuation and Flicker) following provisions of directives applicable

•2006/95/EC (Low Voltage Directive)

•2004/108/EC (EMC Directive)

•2006/95/EC (Amendment of EMC and

Low Voltage Directive) and is produced by a manufacturing organization on ISO9000 level.

Federal Communications Commission (FCC) Notice (U.S. Only)

Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/ TV technician for help.

Caution:

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain compliance with FCC Rules and Regulations.

To prevent damage which may result in fire or shock hazard, do not expose this appliance to rain or excessive moisture.

繁體中文

服務與保證