Philips 8270XL manual Once a Month Razor Head, After Each UseTrimmer

20ENGLISH

C 3 Turn the black 3-pronged locking bracket counterclockwise to unlock (1) and remove the retaining frame (2).

C 4 Remove and clean one set of cutters and combs at a time.

C 5 Separate the cutter from the comb and

rinse clean under hot water.

Do not clean more than one cutter and comb at a time, since they are all matching sets. If you accidentally interchange the cutters and combs, it could take several weeks before optimal shaving performance is restored.

C 6 Replace the set back into the Razor Head Assembly so that the ‘wings’ on the comb fit within the brackets located towards the center of the Assembly.

The set will only fit into the Razor Head Assembly if the ‘wings’ are between the brackets. Make sure that the two pointy edges of the head fit exactly into the recesses.

ENGLISH 21

7	Repeat the process for the other two sets
	of cutters and combs.
8	Replace the frame.
C 9	Press down (1) and turn the black
	3-pronged locking bracket clockwise (2)
	until it locks into place.
10	Close the Razor Head Assembly.

Once A Month: Razor Head

For optimum performance, razor cutters and combs should be cleaned in a degreasing liquid (e.g. rubbing alcohol) and lubricated with one drop of mineral oil (in the center of the head). This helps prevent wear of the shaving heads.

After Each Use:Trimmer

1Turn razor OFF.

C2 Push down spring-release trimmer switch.