16ENGLISH
Once A month: Razor Heads | |
Do not mix up the cutters and combs as the | |
shaving performance may be adversely affected | |
for several weeks before optimal shaving | |
performance is restored. | |
1 | Turn razor OFF, remove the charging plug |
| from the outlet and cord from the razor. |
C 2 | Press the razor head release button, open |
| and lift off the razor head assembly. |
C 3 | Turn the center wheel counterclockwise, |
| and remove the retaining frame. |
4 | Remove and clean one set of cutters and |
| combs at a time. |
C 5 | Separate the cutter from the comb and |
| rinse clean under hot water. |
Do not clean more than one cutter and comb at | |
a time, since they are all matching sets. If you | |
accidentally interchange the cutters and combs, it | |
could take several weeks before optimal shaving | |
performance is restored. | |
C 6 | Replace the set back into the Razor Head |
| Assembly so that the 'wings' on the comb |
| fit within the brackets located towards the |
| center of the assembly. |
◗ The set will only fit into the Razor Head | |
Assembly if the 'wings' are between the | |
brackets. | |
ENGLISH 17
Make sure that the two pointy edges of the comb fit into the recesses.
7Repeat the process for the other two sets of cutters and combs.
8Replace the frame.
1 | C 9 Press down and turn wheel clockwise until |
| it locks into place. |
2
10Replace the Razor Head Assembly back on razor.
Once A Month: Razor Heads
For optimum performance, razor cutters and combs should be cleaned in a degreasing liquid (e.g. Norelco Razor Cleaner, model RC1776, or rubbing alcohol ) and lubricated, with Norelco Razor Lubricant, model AL80, or one drop of mineral oil (in the center of the head).This helps prevent wear of the shaving heads.
After Each Use:Trimmer
1Turn razor OFF.
2 | Push Trimmer Slide Switch up to pop up |
| Trimmer. |
C 3 | Clean Trimmer with the brush every time |
| you use it. |
