ENGLISH
IMPORTANT SAFETY INSTRUCTIONS
When using an electric razor, basic safety precautions should always be followed, including the following:
Read all instructions before using this appliance.
DANGER
To reduce the risk of electric shock:
1.Do not reach for a corded razor that has fallen into water. Unplug immediately.
2.Use razor only in dry condition. Do not use razor while bathing or in a shower.
3.Do not submerge razor in water.
4.Do not place or store a razor while plugged in where it can fall or be pulled into a tub or sink. Do not place or drop a razor into water or other liquid while plugged in.
5.Always unplug this razor from the electrical outlet immediately after use, except when razor is (re)charging.
6.Remove power supply cord from razor before cleaning.
7.When discarding razor, unplug razor and remove rechargeable battery. See Battery Removal instructions.
WARNING
To reduce the risk of burns, fire, electric shock, or injury to persons:
1. | Close supervision is necessary when this |
| razor is used by, on, or near children or |
| invalids. |
2. | Use this razor for its intended household use |
| as described in this manual. Do not use |
| attachments not recommended by Philips |
| Electronics North America Corporation. |
Features
B
C
D
F
E
G
A
ARazor Head Release Button
BProtective Razor Head Cap
CShaving Heads
DRazor Head Assembly
EOn/Off Button
FLED Charging and Low Battery Indicator
G
The tap symbol on the back of the razor indicates that the razor can be rinsed under running tap water.
Charging
◗Charging requires 12 hours.
◗Battery performance is best if you recharge only when the batteries are (almost) completely empty.
◗Charging, recharging or storing at temperatures below 40ºF or higher than 95ºF adversely affects lifetime of batteries.
◗Continuously recharging will reduce life of the batteries.
◗This razor will not operate corded directly from the electrical outlet.
◗Do not leave the razor charging for more than 24 hours.
1Be certain razor is OFF.
2Connect cord to razor (Fig. 2).
3Plug the adaptor into any 120V AC outlet. Use only the cord provided.
◗An adaptor plug may be necessary for charging in some foreign countries. Use an attachment plug adaptor of the proper configuration for power outlet.
4The charging light will light to indicate the razor is (re)charging (Fig. 1).
5Charging requires a full 12 hours. A fully charged razor has a cordless shaving time of up to 30 minutes.
6Disconnect the cord and unplug from the electrical outlet.
Optimize The Working Life of The Battery
◗After razor has been charged for the first time, do not recharge razor until the battery is almost empty.
◗Do not keep plug permanently plugged in.
Recharging
After Every Use: Razor Heads
The quickest and easiest way to clean the razor heads is to rinse them after each use or at least once a week with hot water:Water from the tap should be on a hot setting, BUT BE CAREFUL TO TEST WATER FIRST SO AS NOT TO BURN OR SCALD HANDS.
◗Regular cleaning guarantees better shaving results.
◗Do not immerse razor in water.
1Always turn razor OFF, unplug from outlet and remove cord from razor before cleaning.
2Clean outside of Razor Head Assembly by running under hot water (Fig. 6).
3Press the Razor Head Release Button (1) and pull the Razor Head Assembly off the razor (2) (Fig. 7).
4Clean inside razor heads by running under hot water (Fig. 8).
5Clean inside hair chamber by running under hot water (Fig. 9).
6Put the Razor Head Assembly back on the razor (Fig. 10).
NOTE: Do not wipe or dry the shaving heads with a towel or tissue.This could damage the shaving heads.
Every Two Months: Razor Heads
Do not mix up the cutters and combs as the shaving performance may be adversely affected for several weeks before optimal shaving performance is restored.
| Turn razor OFF. |
1 | |
| Press the razor head release button (1) and |
2 | |
| remove the Razor Head Assembly from the |
Battery Removal
wThis Philips Norelco razor contains a rechargeable Nickel Metal Hydride battery which must be disposed of properly (Fig. 16).
wBattery should only be removed when razor is to be discarded.
wFor assistance, visit our website, www.philips.com/support or call toll free:
1Unplug electrical cord from outlet and razor before dismantling razor.
2Allow razor to run until the battery is empty/depleted.
3Turn razor OFF.
4Use a screwdriver to remove the screw at the bottom of the razor (Fig. 17).
5Remove the battery compartment (1) and remove the battery (2) (Fig. 18).
6Do not attempt to replace battery. Insulate battery ends by covering with tape and/or place battery in a small plastic bag.
7Discard your razor. Do not attempt to plug electrical cord into the outlet or recharge the razor after the battery has been removed.
8Contact your local town or city officials for battery disposal information or call
Assistance
For assistance, call toll free:
Information is available 24 hours a day, 7 days a week.
Electric Razor
912XCordless
Razor
Register your product and get support at
www.philips.com/norelco
4222 002 5196 1
45-DAY MONEY-
BACK GUARANTEE
To enjoy the closest and most comfortable shave from your new Philips Norelco Men’s Razor, the razor should be used exclusively for 3 weeks.This allows your hair and skin enough time to adapt to the Philips Norelco Shaving System. If, after that period of time, you are not fully satisfied with your Philips Norelco Men’s Razor, send the product back along with dated sales receipt
3. | Never operate this razor if it has a damaged | |
|
| cord or charging plug, if it is not working |
|
| properly, if it has been dropped or damaged, |
|
| or dropped into water while plugged in. |
|
| For assistance visit www.philips.com or call |
|
| |
4. | Keep the razor, cord and charging plug away | |
|
| from heated surfaces. |
5. | Never drop or insert any object into any | |
|
| opening. |
6. | Do not charge or plug in razor outdoors or | |
|
| operate where aerosol (spray) products are |
|
| being used or where oxygen is being |
|
| |
|
| administered. |
|
| |
7. | Do not use this razor with a damaged or | |
|
| broken comb, as facial injury may occur. |
8. | Always attach plug to razor first, then to | |
|
| outlet.To disconnect, turn razor off then |
|
| remove charging plug from outlet. |
9. | Never put the razor in direct sunlight or | |
|
| store in a pouch at a temperature above |
|
| 140°F. |
10. | Razor can be rinsed under running tap water. | |
|
| Do not operate razor until fully dried. |
11. | To prevent possible damage to the cord, do | |
|
| not wrap cord around the razor. |
12. | Do not use the razor in combination with | |
|
| |
|
| other cosmetic products. |
SAVE THESE
INSTRUCTIONS
IMPORTANT: The power plug contains a transformer. Do not cut off the power plug to replace it with another plug, as this will cause a hazardous condition.
Registration
Congratulations on your purchase and welcome to Philips Norelco!
To fully benefit from the support that Philips
1 |
4 |
7 |
10 |
13 |
16 |
2 |
5 |
8 |
11 |
14 |
17 |
3 |
6 |
9 |
12 |
15 |
18 |
1Recharging requires a full 12 hours.
2Recharge only when the charging light lights up orange. This indicates there is approximately 3 minutes of operating time left.
3When razor is fully charged, disconnect the power cord from razor and outlet.
Shaving
◗Use this razor for its intended household use as described in this manual.
◗Shaving with a clean, dry face gives the best results.
1Remove protective razor head cap.
2Turn the razor ON by pushing the ON/OFF button (Fig. 3).
3Shave against the direction of beard growth using both straight and circular movements (Fig. 4).
4Stretch your skin with your free hand so blades can lift and cut whiskers. Gently press razor to skin.
DO NOT press too hard. Too much pressure can pinch the skin into the heads.
5Turn the razor OFF by pressing the ON/OFF button.
6Put the protective razor head cap on the
razor to protect razor heads (Fig. 5).
Make sure the nub on the protective razor head cap covers the razor head release button.
Cleaning
| razor housing (2) (Fig. 6). |
| Turn the orange wheel counterclockwise (1) |
3 | |
| and remove the retaining frame (2) (Fig.11). |
| Remove one cutter and comb out of the |
4 | |
| retaining frame (Fig.12). |
| Separate the cutter from the comb (Fig. 13). |
5 | |
| Clean the cutter with the small brush. Brush |
6 | |
| carefully in the direction of the arrows |
| (Fig. 14). |
| Brush the slots of the comb in a circular |
7 | |
| motion (Fig. 15). |
For optimum performance, razor cutters and combs should be cleaned in a degreasing liquid (e.g. Philips Norelco Shaving Head Cleaning Spray, model HQ110 or alcohol).This helps prevent wear of the shaving heads.
8Replace each cutter into the comb and into the retaining frame.
9Put the retaining frame into the Razor Head Assembly and turn the orange wheel clockwise.
10Replace the Razor Head Assembly back on the razor.
This razor has no other
Storage
◗ Be sure razor is turned off. Remove cord from |
outlet and razor before storing in a safe, dry |
location where it will not be crushed, banged, |
or subject to damage. |
Accessories
◗Shaving Head Cleaning Spray
HQ110
◗Philips Norelco Razor Accessories may be purchased at a store near you or on our website www.philips.com/store
and we’ll refund you the full purchase price. The razor must be shipped prepaid by insured mail, insurance prepaid, and have the original sales receipt, indicating purchase price and the date of purchase, enclosed. We cannot be responsible for lost mail.
The razor must be postmarked no later than 45 days from the date of purchase. Philips Norelco reserves the right to verify the purchase price of the razor and limit refunds not to exceed suggested retail price.
To obtain
Full
Philips Electronics North America Corporation warrants each new Philips Norelco Product, Model 912X (except cutters and combs) against defects in materials or workmanship for a period of two years from the date of purchase, and agrees to repair or replace any defective product without charge.
IMPORTANT: This warranty does not cover damage resulting from accident, misuse or abuse, lack of reasonable care, the affixing of any attachment not provided with the product or loss of parts or subjecting the product to any but the specified voltage.* Use of unauthorized replacement parts will void this warranty.
PHILIPS ELECTRONICS NORTH AMERICA CORPORATION WILL NOT PAY FOR WARRANTY SERVICE PERFORMED BY A
In order to obtain warranty service, simply go to www.philips.com/ norelco or call
*Read enclosed instructions carefully. Manufactured for:
Philips Consumer Lifestyle
A Division of Philips Electronics North America Corporation P.O. Box 10313, Stamford, CT 06904
Norelco is a Registered Trademark of Philips Electronics
North America Corporation.
PHILIPS is a Registered Trademark of Koninklijke Philips Electronics N.V.
© 2010 Philips Electronics North America Corporation. All Rights Reserved.
Norelco offers, register your product at www.philips.com/MyNewRazor.
Put It to the Test & Shaving Tips
◗21 Day Trial and Conversion Process. It is a fact that your skin and beard need time to adjust to a new shaving system.
◗Use your new razor exclusively for 3 weeks to fully enjoy the closeness of a Philips Norelco shave.
◗At first you may not get as close a shave as you expect, or your face may even become slightly irritated.This is normal since your beard and skin will need time to adjust. Invest 3 weeks and you’ll soon experience the full joy of your new razor.
◗Stick with it! If you alternate shaving methods during the adjustment period, it may make it more difficult to adapt to the Philips Norelco shaving system.
◗If you are still not convinced after 21 days, Philips Norelco will refund you the full purchase price, guaranteed.
LED Charging Indicator
◗The Charging Indicator Light on the razor will light up green to indicate razor is (re)charging (Fig. 1).
Before First Use
◗Charge the razor before you start using it (see ‘Charging’). Make sure the razor is switched off before you start charging it.
◗Remove any sticker or protective foil from the razor before using.
Important
◗Only use the power cord provided to charge the razor.
◗Regular cleaning guarantees better shaving results.
◗Always switch razor OFF before cleaning.
◗Never clean, remove or replace head assembly while motor is ON.
◗Do not apply pressure to combs. Do not touch razor heads with hard objects as this may dent or damage
◗ Do not wrap cord around razor when |
storing. |
◗ Store cord in a safe location where it will |
not be cut or damaged. |
◗ Do not keep razor permanently plugged into |
outlet. |
◗ Do not place or store razor where it can |
fall or be pulled into a tub or sink, water |
or other liquid while plugged in. |
◗ Put the Protective Razor Head Cap on razor |
to protect heads. |
10_912X.indd 1
1/15/10 9:18:06 AM
