Philips AJ3136 warranty Battery LOW Mode, Setting the Clock and Alarm Times, General Features

BATTERY LOW MODE

If you have inserted batteries, the battery low indicator lights up when:

SETTING THE CLOCK AND ALARM TIMES

The time is displayed using the 12-hour clock with PM indicator (PM off = AM).

• battery power is low.

During the battery low mode, both Radio/Sleep, sound effects, backlight will not function.

Operation of any alarm mode (Radio/Buzzer/Submarine/Frog) automatically changes to a slow buzzer beep frequency.

•If the RADIO ON / OFF, ALARM RESET / SLEEP or

REPEAT ALARM•BRIGHTNESS CONTROL button is pressed, the battery low indicator will flash for 5 seconds and then remains non-blinking.

Setting the clock time

1. Press SET AL / TIME twice within a second to enter the clock time setting mode.

™The clock time display flashes and you will hear a short beep.

2.Hold down or press HOUR + or MIN + repeatedly to set and adjust the hours and minutes respectively. Release HOUR + or MIN + when you have reached the correct setting.

3.After both the hours and minutes are set, press SET AL / TIME to confirm the setting.

		R PEAT	E
			A LA
			RM •	BRIG
				HT
				NES
		R		SC
	U				N
					T
H O					O
		PM			R
					O
					L
		PM
				NI	M

GENERAL FEATURES

Reset

Should you receive external interference e.g. static electricity from carpets, thunder- storms, etc. Which affects the display and electronic functions of your set, RESET allows you to clear all previous settings and start up again.

• Use a ballpoint pen to press RESET , found inside battery compartment.

Demo mode

When the set is first connected to a power supply or has been reset, ‘PHILIPS’ will scroll continuously across the demonstration display.

•Press SET AL / TIME to exit the demo mode, before you set the times or press RADIO ON / OFF or ALARM RESET / SLEEP to switch on the Radio.

Illumination brightness

Press REPEAT ALARM•BRIGHTNESS CONTROL once or more.

•The brightness of the display will change in this sequence: off ➟ bright (5 seconds) ➟ OFF (for batteries)

Note:

When the alarm or SLEEP function is active, the brightness cannot be adjusted.

™You will hear two short beeps.

Setting the alarm time

1.Press SET AL / TIME once to enter the alarm time setting mode.

™ lights up and the alarm time display flashes. You will hear a short beep.

2.Hold down or press HOUR + or MIN + repeatedly to set and adjust the hours and minutes respectively. Release HOUR + or MIN + when you have reached the correct setting.

3.After both the hours and minutes are set, press SET AL / TIME to confirm the setting.

™You will hear two short beeps.

™Display returns to clock time.

•Time setting is also automatically confirmed after 10 seconds after you set the time.

•It is not possible to adjust the alarm time during an alarm call or the repeat alarm mode.

RADIO (FM only)

1Press RADIO ON / OFF once to switch on the radio. ™ Display shows ‘ON’ shortly.

2Adjust TUNING to find your radio station.

3Adjust the sound using VOLUME.

4Press RADIO ON / OFF to switch off.

To improve reception:

•Extend and position the pigtail fully to obtain optimum reception.