RADIO
You can use this set solely as a radio!
1
AdjustRADIO OFF
/
ONto ON to switch on the radio.
2
Select your waveband by adjusting the BANDswitch
.
3
AdjustTUNING to tune to your desired station
.
4
Turn the VOLUMEcontrol to adjust the volume level
.
5
AdjustRADIO OFF
/
ON toOFF to switch off the radio.
Toimprove reception:
FM: extend and
position the pigtail for optimum reception
.
AM:
uses a built-in aerial inside the set. Direct the aerial by adjusting the
position of your set
.
SETTING THE CLOCK ANDALARM TIMES
The time is displayed using the 24-hour clock
IMPORTANT!
Toadjust the clock and alarm times accurately, always make sure
you press the
7
or
buttons separately and not simultaneously.
1
Turn the clock controlto SET TIME or SET ALARM 1 or SET ALARM 2 to
set the clock or alarm time respectively.
2
Press
7
or
repeatedly or hold down on the respective button to adjust the
hours and minutes.
3
Release
7
or
when you reach the correct setting.
4
After you have set both the hour and minutes, turn the clock controlto
CLOCKto run on clock time.
SELECTING THE ALARMMODE
GENERAL
If you wish to use the alarm, you must first set the alarm time first. You can choo-
se from two different alarm modes to wake you up: by radio or buzzer.
Select your choice of alarm mode by adjusting ALARM 1or ALARM 2 to RAD
orBUZ.
The 2 buzzers are at a set volume and cannot be adjusted. BUZon
ALARM 1is a low tone buzzer while BUZ on ALARM 2 is a high tone.