CLOCK | RADIO | ALARM |
SETTING THE CLOCK
Clock display
The time is displayed using the
1.Adjust the clock control to the TIME SET position.
2.Press and hold down the 7 or 4 buttons to set and adjust both the hours and the minutes.
–With your finger held down on 7, the time will increase rapidly and continuously from minutes to hours.
–With your finger held down on 4, the time will slowly count down minute by minute.
3.Release the 8 or 4 buttons when you have reached the correct setting.
4.To safeguard the clock time from being accidentally adjusted, turn the clock control to the RUN position.
RADIO
You can use this clock solely as a radio.
1.Set the RAD switch to ON.
2.Select your wave band using the BAND switch.
3.Tune to desired radio station using the TUNING knob.
4.Set the volume by turning the VOLUME control.
5.To turn off the radio, set the RAD switch to OFF.
To improve radio reception
–For AM, (MW or LW ) the set is provided with a
–For FM , extend the pigtail wire at the back of the set completely for optimum reception.
SETTING THE ALARM
General
If you wish to use the alarm, then you should first set the alarm time. There is also the choice of two modes for waking you up: by buzzer or radio. The display will show the alarm indicator in the bottom left or right corners if the alarm is set.
1.Adjust the clock control to the ALARM 1 or 2 position.
2.Press and hold down the 7 or 4 buttons to set and adjust both the hours and the minutes.
–With your finger held down on 7, the time will increase rapidly and continuously from minutes to hours.
–With your finger held down on 4, the time will slowly count down minute by minute.
3.Release the 7 or 4 buttons when you have reached the correct setting.
4.Adjust the clock control to the RUN position to return to clock time display.
–To review your set alarm time, adjust the clock control to the respective ALARM 1 or 2 position.
5.To select the alarm mode you wish to be awoken by, set the respective AL 1 or 2 switch to RAD or BUZ.
–If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you.
–The 2 buzzers are at a set volume and cannot be adjusted. BUZ on AL 1 is a low tone buzzer while BUZ on AL 2 is a high tone.
English
5
