Problem
–Possible cause
•Remedy
No sound /power
–Volume not adjusted
•Adjust the VOLUME
–Power cord not securely connected
•Connect the AC power cord properly
–Batteries dead/ incorrectly inserted
•Insert (fresh) batteries correctly
–Headphones connected to the set
•
Disconnect headphones.
Display does not function properly/
No reaction to operation of any of the
controls
–Electrostatic discharge
•Switch off and unplug the set. Reconnect after a
few seconds
Severe radio hum or noise
–Electrical interference: set too close to TV,VCR or
computer
•Increase the distance.
Poor radio reception
–Weak radio signal
•FM/SW: Adjust the FM telescopic antenna
•MW: Direct this antenna for best reception
by turning the whole set.
Poor cassette sound quality
–Dust and dirt on the heads, etc.
•Clean deck parts, see Maintenance
–Use of incompatible cassette types (METAL or
CHROME)
•Only use NORMAL (IEC
I
) for recording
Recording does not work
–Cassette tab(s) may be broken
•Apply adhesive tape over the missing tab space
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.