Philips AQ6691/01Z manual Power Supply, Setting The Clock, Radio Reception, Battery not included

POWER SUPPLY SETTING THE CLOCK RADIO RECEPTION

English

POWER SUPPLY

Mains Adapter (not included)

The voltage of the 3V adapter must match with the local voltage. The 3.5 mm adapter plug's 1.3 mm centre pin must also be connected to the minus pole -.

•Connect the mains adapter to the set's DC 3V socket and a wall socket.

•Always disconnect the mains adapter if you are not using it.

Battery (not included)

•Open battery door and insert two alkaline batteries, type R6, UM3 or AA as indicated.

•Remove the batteries from the set if they are exhausted or not to be used for a long time.

–When the batteries are running low, flashes in the display. If the radio is on, it will automatically switch off.

–It may be necessary to reprogramme your preset stations.

SETTING THE CLOCK

Clock display

The time is displayed using the 24-hour clock system. The clock display is shown when the radio and cassette functions are switched off.

1Press TIME SET.

–The clock digits flash for about 5 seconds when you press TIME SET.

2To set the hour/minutes, press HOUR or MIN while the display is still flashing.

–With your finger held down on HOUR, the hour increases steadily as a number from 0-23. Release HOUR when you reach the correct hour setting.

–With your finger held down on MIN, the minutes increase rapidly and continuously. Press briefly and repeatedly if you need to adjust the minutes slowly.

– When the clock digits stop flashing, the time is set.

RADIO RECEPTION

1Connect headphones to the p socket.

2Press RADIO ON/OFF•BAND to switch on the radio.

3Press RADIO ON/OFF•BAND again to select AM or FM waveband.

–The display shows the radio station details throughout the radio mode.

–FM ST appears on the display when you are receiving a FM stereo transmission.

4Select your station by pressing one of the preset numbers (1-5), or by using the TUNING controls + or –.

4