Philips AT756, AT941, AT890 Cleaning and maintenance, Cleaning the shaving unit under the tap

12ENGLISH

Cleaning and maintenance

Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the shaver and the charging stand (AT941/AT940 only).

Always unplug the shaver before you clean it under the tap.

-- Clean the shaver after every shave for optimal shaving performance. -- Regular cleaning guarantees better shaving performance.

-- For the best cleaning results, we advise you to use the Philips Cleaning spray (HQ110).

-- Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt.

Note:Water may leak from the socket at the bottom of the shaver when you rinse it.This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver.

Cleaning the shaving unit under the tap

1Switch off the shaver.

2 Press the release button to open the shaving unit.

3 Rinse the shaving unit and hair chamber under a hot tap for 30 seconds.

Be careful with hot water.Always check if the water is not too hot, to prevent your hands from getting burnt.

-- Rinse the hair chamber and the inside of the shaving unit.

-- Rinse the outside of the shaving unit.

4 Close the shaving unit and shake off excess water.

Be careful not to hit the shaving unit against anything while shaking off excess water.

Never dry the shaving unit and the hair chamber with a towel or tissue, as this may damage the shaving unit.

5Open the shaving unit again and leave it open to let the shaver dry completely.