GENERAL INFORMATION / CD PLAY
In-car use (connections supplied or optionally available)
Only use the a 4.5 V DC Car voltage converter (positive pole to the centre pin) and car adapter cassette. Any other product may damage the set.
1Put the set on a horizontal,
ger nor an
obstacle to the driver and the passengers.
2 Plug the voltage converter into the cigarette lighter socket (only for 12 V car battery, negative grounding), then connect the wired end with 4.5V DC input socket on the set.
4,5 V DC
3If necessary, clean the cigarette lighter socket to obtain a good electrical contact.
4Turn down the volume and connect the cassette adapter plug to LINE OUT/p on the set.
5Carefully insert the cassette adapter into the car radio’s cassette compartment.
6Make sure the cord does not hinder your driving.
7Decease the volume on the set, if necessary. Start playback on the set and adjust the sound with the car radio controls.
•Always remove the voltage converter from the cigarette lighter sock- et when the set is not in use.
Note: If your car radio has a LINE IN socket , it is better to use it for the
car radio connection instead of the cassette adapter. Connect the signal lead to this LINE IN socket and to LINE OUT/p on the set.
Playing a CD
This
1Push the OPEN 2 slider to open the player.
2Insert an audio CD, printed side up, by pressing the CD onto the hub.
3Close the player by pressing the lid down.
4Press 2; to switch the player on and start playback.
y The current track number and elapsed playing time are displayed.
•You can pause playback by pressing 2;.
y The time at which playback was paused starts
flashing.
• You can continue playback by pressing 2; again.
5Press 9 to stop playback.
y The total number of tracks and the total playing time of the CD are displayed.
6Press 9 again to switch the player off.
• To remove the CD, hold it by its edge and press the hub gently while lifting the CD.
Note: If there is no activity, the set will automatically switch off after a while to save energy.
CD PLAY / FEATURES
Playback information
•If a
•When playing a
•Playback will stop and the set will turn off if you open the CD lid.
•While the CD is read, 01
Volume and bass
Volume adjustment
• Adjust the volume by using VOL E.
Bass adjustment
•Press DBB to switch the bass enhancement on or off
y DBB appears if the bass enhancement is activated.
Selecting a track and searching
Selecting a track during playback
•Briefly press ∞ or § once or several times to skip to the current, previous or next track.
y Playback continues with the selected track, and the track’s number is displayed.
Selecting a track when playback is stopped
1Briefly press ∞ or § once or several times to select the desired track. The track number is displayed.
2Press 2; to start CD play.
y Playback starts with the selected track.
Searching for a passage during playback
1Keep ∞ or § pressed to find a particular passage in a backward or forward direction.
y Searching starts while playback continues at low volume. After 2 seconds the search speeds up.
2Release the button when you reach the desired passage. y Playback continues from this position.
Notes: – If the player is in SCAN mode (see MODE chapter), searching is not possible.
–In shuffle, shuffle repeat all or repeat mode (see MODE chapter), or while playing a program, searching is only possible within the particular track.
