Philips AZ1008 manual Troubleshooting, Problem Solution

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as there is a risk of electric shock.

If you are unable to remedy a problem by following these hints, consult your dealer or service center.

WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.

English

Problem	Solution
No sound	– Adjust the VOLUME
Power cord not securely	– Connect AC power cord properly
connected
Batteries dead /incorrectly	– Insert (fresh) batteries correctly
inserted

Display does not function properly/ No reaction to operation of any of the controls

–Electrostatic discharge

–Switch off and unplug the set. Reconnect after a few seconds.

Er indication	– No CD inserted, insert a CD
CD badly scratched or dirty	– Replace/ clean CD, see Maintenance
Laser lens steamed up	– Wait until lens has cleared
	– Wait until lens has acclimatized

CD-(R) is blank or the disc is not finalized

– Use a finalized CD-(R)

CD playback does not work	– CD badly scratched/ dirty. Replace/ clean CD (see
	maintenance)
The CD skips tracks	– CD damaged or dirty. Replace or clean CD.
	– Program is active. Quit program mode
Poor cassette sound quality	– Dust and dirt on the heads, etc.
	Clean deck parts, see maintenance.
	– Use of incompatible cassette types (METAL or
	CHROME). Only use NORMAL (IEC I) for recording
Recording does not work	– Cassette tab(s) may be broken. Apply a piece of
	adhesive tape over the missing tab space.

15